HowTo Use The NST WUI arp-scan Page To Quickly Locate Hosts
Locating the "arp-scan" Page In The NST WUI
The arp-scan page can be found in the NST WUI using the main menu bar. Select Security -> Active Scanners -> arp-scan as shown in the image below:
Running A Scan
Running a arp-scan is fairly straight forward. Basically, you will:
- Select a network interface to use for the scan.
- Specify a range of IP addresses to scan, or select Local Network if you want to scan every address on the network associated with the interface.
- Optionally open up the Advanced Options area and make some adjustments.
- Press the Run button.
- Wait a few seconds, a few minutes, or hours for the scan to complete. It depends on the address range being scanned as well as various scan options which you can adjust.
- Review the results.
The image below, shows that the p2p1 interface was selected to be scanned and the every host on the p2p1 local network will be scanned. Since it was already known that the p2p1 network in this example was a 192.168.1.0/24 network, we knew it would only take a couple of seconds for the scan to complete. Had the p2p1 been a stealth interface or on a large 10.0.0.0/8 network, we would have specified a specific range of IP addresses to scan.
To start the arp-scan the Run button was pressed. The arp-scan progress widget (shown below) was then displayed while the scan went through all of the possible IP addresses.
Once complete, the progress widget will automatically hide itself after a couple of seconds and you will see the final results. If you would like to review the information displayed on the progress widget, press the Hold button before the scan completes.
Reviewing The Results
After a arp-scan run completes, you should see a table of IP addresses, host names, MAC addresses and MAC manufacturers similar to what is shown below:
There are many things you can do with the results table:
- You can click on the column headers to sort (or reverse sort) the table by the data contained in the column.
- You can click on any IP address in the table to use other tools in the NST WUI which work with IP addresses.
- You can click on any MAC address in the table to use other tools in the NST WUI which work with MAC addresses.
- You can use the Show Last Results button to see the raw ASCII output from the arp-scan command which was run.
- You can use the Download Last Results button to download the raw ASCII output from the arp-scan command which was run.
- You can use the Download PCAP button to download the PCAP file containing the ARP packets from the scan. This file can be loaded into tools like wireshark.
- You can use the XML button to download a XML file containing the results from the last arp-scan command which was run.
There are many other advanced options which you can specify before running arp-scan. Press the Advanced button to display (or hide if shown) the advanced options. All of the advanced options have tool tips describing what they do. Simply hover your mouse pointer over the option for details. The image below shows the tool tip associated with the Add Self button.