Wireless Setup Tips

More Information

While a bit dated, the "Wireless" section in the NST FAQ still has many useful tips related to using wireless cards.

Wireless and the NST Virtual Machine

When running the NST distribution within a VMware virtual machine, it is important to remember that any physical wireless cards in the system will appear as Ethernet cards to the NST. This is due to the manner that VMware virtualizes and presents wireless cards to the virtualized environment. When used in this manner, the virtualized NST system will be limited to using wireless cards as if they were standard Ethernet NICs.

For full access to the wireless tools included in the NST distribution, one will either need to boot the system directly from the Live CD or a hard disk installation of the NST.

WPA-PSK Setup

Starting with the 1.8.0 release of the NST, support for setting up WPA and WPA2 connections using the PSK (pre-shared key) method has been provided.

While not quite as simple as using the NetworkManager available on a Fedora Gnome desktop, a WUI page has been provided to make setting up a WPA-PSK connection a fairly painless process.

Assumptions

• A laptop will be used to boot the NST distribution, and this laptop will have no wired connections.

• The laptop will contain a wireless card compatible with the NST distribution (we have had good luck with Aetheros and Intel based cards).

• A access point which supports WPA or WPA2 access using the PSK method is available.

• One knows the ASCII value of the PSK (the pass phrase required to connect).

Summary

• Boot the NST from the Live CD (a hard disk boot is also acceptable).

• Setup/Start X so that we can launch Firefox.

• Bring up the WPA-PSK setup page in Firefox.

• Enter the SSID and PSK of the wireless network and press the Connect button to connect to the network.

• Stop the X server (and optionally restart it).