Hard Disk Install Setup Tips

HD Installation Recipe

The following details a set of steps to Partition Hard disk to accept two NST installations and 3 ethernet NICs.

HD Install

• Boot From CD
• Log in
• cfdisk
  • create 2G NST install #1 /dev/hda1 Make bootable
  • create 2G NST install #2 /dev/hda2
  • Create 1G swap /dev/hda3
  • create /dev/hda4 for /var/nst
• reboot

• nsthdinstall
  • nsthdinstall --device /dev/hda2 --format --label "NST v1.5.0-2" --swap-devices /dev/hda5 --swap-format-label --grub-install
  • nsthdinstall --device /dev/hda1 --format --label "NST v1.5.0-1" --swap-devices /dev/hda5 --swap-format-label --grub-install
  • reboot to HD.

• • Login with nst@2003 password.
  • Create var partition, and move var to it:

mke2fs -c /dev/hda4
mkdir /newvar
mount /dev/hda4 /newvar
cd /var
cp -ax * /newvar
cd /
mv var oldvar
mkdir var

• Edit /etc/fstab to add

/dev/hda4            /var              ext2            defaults                        1 2

• reboot

Host Name

{{{nsthostname -n nprobe2}}}

NIC Setup

All nodes but gr at 10.x.1.6

* cdnet
  * Set probe ports eth0 and eth1 to static
  * Set management port eth2 (the onboard nic) to static, and set ip address 10.<campus>.1.6

[root@nprobe9 network-scripts]# cat ifcfg-eth0 DEVICE=eth0 BOOTPROTO=none ONBOOT=yes

1. PROBE PORT 3com NIC

[root@nprobe9 network-scripts]# cat ifcfg-eth1 DEVICE=eth1 BOOTPROTO=none ONBOOT=yes

1. PROBE PORT 3com NIC #2

[root@nprobe9 network-scripts]# cat ifcfg-eth3 DEVICE=eth3 BOOTPROTO=static ONBOOT=yes IPADDR=10.9.1.6 GATEWAY=10.9.1.1 NETMASK=255.255.255.0 BROADCAST=255.255.255.255 NETWORK=10.9.1.0

1. onboard nic management interface

Set the probe nic to monitor the vlan or interlink you wish to monitor. For a campus, this would be typically vlan2 on the core switch, to monitor all traffic inbound/outbound to the campus.