Console Output and Serial Terminals: Difference between revisions
| Line 22: | Line 22: | ||
</pre> | </pre> | ||
</div> | </div> | ||
To get the serial console status use: | To get the serial console status use the '''systemctl''' command as follows: | ||
<div class="screen"> | <div class="screen"> | ||
<div class="userInput"><span class="prompt">[root@probe ~]# </span>systemctl status serial-getty@ttyS0.service</div> | <div class="userInput"><span class="prompt">[root@probe ~]# </span>systemctl status serial-getty@ttyS0.service</div> | ||
Revision as of 07:17, 20 May 2011
Overview
This page describes different methods for setting up a serial console post booting up an NST system. See Getting Started - Server Boot for setting up a serial console initially during a NST Live boot.
Serial Console On NST 2.13.0
Use the following command to manually enable the serial console on NST versions 2.13.0 using upstart. This example will set the serial baud rate to: "57600" and use serial device: "/dev/ttyS0".
[root@probe ~]#
Serial Console On NST 2.15.0 or Above
Use the following command to manually enable the serial console on NST versions 2.15.x or above using systemd. This example will use the current baud rate (agetty -s option) set typically during a boot time and use serial device: "/dev/ttyS0". If one needs to adjust the baud rate, send a break character on your communications application to cycle through the baud rate list (i.e., In this example: 115200, 38400 and 9600).
[root@probe ~]#
To get the serial console status use the systemctl command as follows:
serial-getty@ttyS0.service - Serial Getty on ttyS0
Loaded: loaded (/lib/systemd/system/serial-getty@.service)
Active: active (running) since Tue, 17 May 2011 16:59:56 -0400; 5min ago
Main PID: 31524 (agetty)
CGroup: name=systemd:/system/serial-getty@.service/ttyS0
└ 31524 /sbin/agetty -s ttyS0 115200 38400 9600
[root@probe ~]#
