Difference between revisions of "HowTo Recreate Grub Install And The Master Boot Record (MBR) If Corrupted"

From NST Wiki
Jump to navigationJump to search
Line 25: Line 25:
 
  <pre class="computerOutput">
 
  <pre class="computerOutput">
 
/dev/sdb1 umounted
 
/dev/sdb1 umounted
 +
[root@probe ~]#
 +
</pre>
 +
</div>
 +
 +
 +
 +
* '''3)''' Mount "'''/boot'''" using partition: "''/dev/sda1'''":
 +
<div class="screen">
 +
<div class="userInput"><span class="prompt">[root@probe ~]# </span>mount -v /dev/sda1 /boot</div>
 +
<pre class="computerOutput">
 +
mount: you didn't specify a filesystem type for /dev/sda1
 +
      I will try type ext3
 +
/dev/sda1 on /boot type ext3 (rw)
 
[root@probe ~]#
 
[root@probe ~]#
 
</pre>
 
</pre>
 
</div>
 
</div>

Revision as of 19:43, 25 October 2009

  • Problem: When booting NST from a hard disk install and you see the message: "Disk Error" (or something similar) on the screen after POST.
  • Solution: Typically, this is associated with a corrupt grub install and/or MBR on the hard disk. Use this HowTo to help recreate the grub install and MBR to help resolve this issue.


This HowTo shows the steps one can used to recreate a corrupt grub boot loader install and/or MBR on an NST system. Start by booting up "NST Live" (DVD or USB Flash Drive) or NST on a "USB Flash Drive" hard disk install. This example assumes the corrupt grub install and/or MBR is on the disk associated with device name: "/dev/sda" were partition: "/dev/sda1" is used for grub and the MBR is on "/dev/sda" sector 0.

  • 1) Make sure that there are no mounts using the "/boot" mount point:
[root@probe ~]# df
Filesystem           1K-blocks      Used Available Use% Mounted on
/dev/mapper/vg_probe-lv_root
                     235338552   4335136 228613664   2% /
/dev/sdb1               198337     22358    165739  12% /boot
tmpfs                  1419416         0   1419416   0% /dev/shm
[root@probe ~]#


  • 2) Unmount "/boot" if currently mounted:
[root@probe ~]# umount -v /boot
/dev/sdb1 umounted
[root@probe ~]#


  • 3) Mount "'/boot" using partition: "/dev/sda1":
[root@probe ~]# mount -v /dev/sda1 /boot
mount: you didn't specify a filesystem type for /dev/sda1
       I will try type ext3
/dev/sda1 on /boot type ext3 (rw)
[root@probe ~]#