HowTo Geolocate Active Connection Information

From NST Wiki
Revision as of 10:46, 26 April 2011 by Paul Blankenbaker (talk | contribs) (Screen Casts)
Jump to navigationJump to search

Quick Start

  • Set up your NST system such that it can geolocate IP addresses (see: HowTo Setup The NST System To Geolocate Data).
  • From the NST WUI menu bar select the Network menu, then Monitors and finally Active Connections.
  • Explore the controls and information displayed and try out Map mode (Hint: there are tool tips everywhere).

Screen Casts

The Active Connection Introduction screencast provides a introduction and overview to the Active Connection page.

EmbedVideo was given an illegal value for the alignment parameter "360". Valid values are "left", "center", or "right".